IEC PAS 62515:2007 pdfダウンロード

IEC PAS 62515:2007 pdfダウンロード。Requirements concerning the interoperability between electromechanical and electrical applications in CAx-systems
Scope
This PAS is intended to serve as a checklist and guideline for the evaluation of CAx-softwarefor applications within the electromechanical field by users in industry.
This PAS provides a set of data element types required in the context of electromechanicaapplications,especially in the context of electrical applications and their mechanical representations in the real or virtual three-dimensional world.
Where possible, existing internationally standardized data element types have been taken fromthe existing data element repository as listed in the data base of IEC 61360 available under theURL http;//std.iec.ch/iec61360
Available data element types are indicated by their identity number, followed by its name andthe definition as given in the data base at the time of publication of this document.
The application of standardized data element types supports the automatization of designprocesses during the developent of products, systems and plants.
Normative references
The following referenced documents are indispensable for the application of this document. Fordated references, only the edition cited applies. For undated references, the latest edition ofthe referenced document (including any amendments) applies.
IEC 60027 (all parts) Letter symbols to be used in electrical technology
IEC 60715:1981,Dimensions of low-voltage switchgear and controlgear Standardized mounting on rails for mechanical support of electrical devices in switchgear and controlgear installations
IEC 61346-1:1996.Industrial systems, installations and equipment and industrial products -Strucfuring principles and reference designations – Part 1: Basic rules
IEC 61360-4:DB, Standard data element lypes with associated c/assification scheme for electric components Part 4: IEC reference collection of standard data element types and component classes
IEC 61666:1997,Industrial syslems – Installations and equipment and industrial products -Identification of terminals within a system
IEC 81714-3:2004,Design of graphical symbols for use in the technical documentation of products – Part 3: Classification of connect nodes, networks and their encoding
ISO 31 (all parts), Quantities and units
ISO 128 (all parts), Technical drawings – General principles of presentation