IEC 62386-207:2009 pdfダウンロード

IEC 62386-207:2009 pdfダウンロード。Digital addressable lighting interface – Part 207: Particular requirements for control gear – LED modules (device type 6)
Scope
This lnternational Standard specifies a protocol and test procedures for the control by digitasignals of electronic control gear for use on a.c. or d.c. supplies, associated with LEDmodules.
NOTE Tests in this standard are type lests. Requirements for testing individual control gear during production arenot included.
2Normative references
The following referenced documents are indispensable for the application of this documentFor dated references, only the edition cited applies. For undated references, the latest editionof the referenced document (including any amendments) applies
IEC 62386-101:2009, Digital addressable lighting interface – Part 101: General requirementsSystem
IEC 62386-102:2009, Digital addressable lighting interface – Part 102: General requirements Control gear
3 Terms and definitions
For the purposes of this document, the terms and definitions given in Clause 3 otEC 62386-101:2009 and Clause 3 of IEC 62386-102:2009 shall apply, with the followingadditional definitions.
3.1
reference measurement
process during which control gear determines the actual LED load with internal proceduresand measurements
NOTE The details of this process are a matter of detailed design of control gear and are outside the scope of thisstandard.
3.2
detection of load decrease
recognition that the actual LED load is significantly below the load measured during a
successful”reference measurement”
NOTE The criterla for regarding a load increase or decrease as significant can only be decided by themanufacturer and these criteria should be described in the manual.
3.3
detection of loadincreaserecognition that the actual LED load is significantly above the load measured during asuccessful“reference measurement”
NOTE The criteria for regarding a load increase or decrease as significant can only be decided by themanufacturer and these criteria should be described in the manual.
3.4
current protectorprotective device switching off the output if the actual LED load differs by more than AP fromthe load detected during the “reference measurement
NOTE The value AP can only be specified by the manufacturer of the control gear and this value should be stated
in the manual.
3.5
thermal overload
scenario where the maximum permissible control gear temperature is exceeded
3.6
thermal shut down
scenario where control gear switches off the LED because of a persistent thermal overload
3.7
light level reduction due to thermal overloadreduction of light level with the objective of decreasing control gear temperature
General
4 The requirements of Clause 4 of IEC 62386-101:2009 and Clause 4 of lEC 62386-102:2009apply.
Electrical specification
5 The requirements of Clause 5 of lEC 62386-101:2009 and Clause 5 of IEC 62386-102:2009apply.
6 Interface power supply
The requirements of Clause 6 f IEC 62386-101:2009 and Clause 6 of IEC 62386-102:2009apply, if a power supply is integrated with the control gear.
7Transmission protocol structure
The requirements of Clause 7 of IEC 62386-101:2009 and Clause 7 of EC 62386-102:2009apply.
8Timing
The requirements of Clause 8 of IEC 62386-101:2009 and Clause 8 of EC 62386-102:2009apply.
9Method of operation
The requirements of Clause 9 of IEC 62386-101:2009 and Clause 9 of lEC 62386-102:2009apply, except as follows:
Addition to Clause 9 ofIEC 62386-102:2009