IEC 62386-206:2009 pdfダウンロード

IEC 62386-206:2009 pdfダウンロードDigital addressable lighting interface – Part 206: Particular requirements for control gear – Conversion from digital signal into d. c. voltage (device type 5)
Scope
This lnternational Standard specifies a protocol and test methods for the control by digitasignals of electronic control gear, associated with the conversion from digital signal into d.cvoltage.
2Normative references
The following referenced documents are indispensable for the application of this documentFor dated references, only the edition cited applies. For undated references, the latest editionof the referenced document (including any amendments) applies.
EC 62386-101:2009,Digital addressable lighting interface – Part 101: General reguirements- System
IEC 62386-102:2009, Digital addressable lighting interface – Part 102: General requirementsControl gear
Terms and definitions
For the purposes of this document, the terms and definitions given in Clause 3 ofIEC 62386-101:2009 and Clause 3 ofIEC 62386-102:2009 apply.
4General description
The requirements of Clause 4 of IEC 62386-101:2009 and Clause 4 of IEC 62386-102:2009shall apply.
Electrical specifications
The requirements of Clause 5 of IEC 62386-101:2009 and Clause 5 of lEC 62386-102:2009shall apply.
6 Interface power supply
The requirements of Clause 6 of IEC 62386-101:2009 and Clause 6 of IEC 62386-102:2009shall apply if a power supply is integrated with the control gear.
Transmission protocol structure
The requirements of Clause 7 of IEC 62386-101:2009 and Clause 7 of EC 62386-102:2009shall apply.
8 Timing
The requirements of Clause 8 of IEC 62386-1 01 :2009 and Clause 8 of IEC 62386-1 02:2009 shall apply.
9 Method of operation
The requirements of Clause 9 of IEC 62386-1 01 :2009 and Clause 9 of IEC 62386-1 02:2009 shall apply, with the following exception:
Addition to Clause 9 of IEC 62386-102:2009:
9.9 Changing of physical min level
Changing the physical minimum level shall force the minimum level and maximum level to be in a valid range.
If operating with the logarithmic dimming curve, the PHYSICAL MIN LEVEL can be adjusted to allow the minimum arc power level of connected control gear to be matched to the logarithmic dimming curve of 9.1 of IEC 62386-1 02:2009.
A control gear with physical minimum arc power level of X %, requires the “PHYSICAL MIN LEVEL” to be set as follows: